Insulation Application

Roof Application – Method 1 (Normal Roofs)
  1. Clean and dust off the concrete surface of the roof.
  2. Apply water proofing layer (bitumen or any other) on the roof.
  3. Place polythene layer to cover the entire roof (only necessary if bitumen waterproofing is used)
  4. Install THERMOBOARD® sheets by placing them side by side.
  5. Cover with a layer of polythene.
  6. The roof is closed with mud for sloping followed by roofing tiles.
Roof Application – Method 2 (Terraces Etc)
  1. Clean and dust off the concrete surface of the roof.
  2. Apply water proofing layer (bitumen or any other) on the roof.
  3. Place polythene layer to cover the entire roof (only necessary if bitumen waterproofing is used).
  4. Install THERMOBOARD® sheets by placing them side by side.
  5. Place thin steel bar mesh (or crushed stone / gravel) to prepare for concrete pouring.
  6. Finish the roof with screeding.
Cavity Wall Insulation
  1. Place THERMOBOARD® sheets along the inner side of main 9.5” load bearing wall.
  2. Build a thin single-brick interior wall along the insulation sheets to enclose them.
Exterior Wall Insulation
  1. Prepare the exterior wall by cleaning and smoothening surface.
  2. Attach THERMOBOARD® sheets on the outside of the exterior wall with mechanical fasteners and adhesive (optional).
  3. Coat single layer of plaster on the insulation sheets.
  4. Place thin fibre mesh and reinforce with another coat of plaster.
  5. Finish wall with any exterior acrylic based coating.